1.Machine control panel
Our control panel made by stainess steel which is strong,beautiful and not easy to broken compare with the low cost plastic control panel which many other domestic supplier chosen.
2.Control switch
Xingyi adopt exported Schneider series control switch,which have a good ppularity among the world.
3.Swing lever and retaining plate
Xinyi adopt WEDM to create chamfering process,high precision.Base on this technology ,swing lever is combine with retaining plate compactly in case any block or inflexible apprear when changing the position of swing lever.
BTW:The retaining plate have been electroplated to prevent rust when thebaked outer layer of retaining plate was being scratched.
4.Gear Box Cover
XINGYI use iron base gear box cover which protect gear box and not easy to broken. Other domestic suppliers use reinforced plastics gear box cover which is easy to damage and lower cost.
5.Gear box
The gear box is made of aluminum alloy castings, good cooling infrastructure,not easily deformed. Fine processing in CNC machining centers, primary processing molding process to reduce errors occur and extend the life of machine.
Other domestic suppliers use welded-steel plate,bad cooling infrastructure and easy deformed.hard to maintance,once the oil leaking,the gear box is hard to be repair.
6.Gear
All gears of xingyi machine are above 11mm,they are all heavy-duty helical gear.
Helical gear transmission is relatvely stable,strong carry capacity,small noise and less chock.the ordinary life can reach 3 years.The heavy -duty helical gear can reach 5 years normally.
7.Bearing
SKF bearing is famous for its good quality and long lifespan. The bearing in the grinder not only need to reduce friction, heat and abrasive wear, also to stand high loading. SKF meet all the requirement.
8.Oil sealing
All oil sealing are all adopt imported TTO oil seal.
Ordinary rubber seal uses spring-loaded tip lip, The contact area withbearing only 0.3-0.5mm, TTO oil seal lip with wide dynamic structure Wide spring contact.The contact area with bearing of 5-7mm, so you can maintain a adequate oil film, and eccentric shaft
insensitive to beat 0.4mm conditions can still work in the radial direction.